Grabit® Extractor Kit

• Reusable – just clean off chips and lubricate
• Removes stripped-out and damaged screws quickly and easily
• Removes most screw types including Phillips, TORX®, square drive, Pozidriv® and most tamper-proof screws
• For use in variable speed hand drills set in reverse
Burnishing:
1. Insert remover end of GRABIT® directly into drill.
2. Set drill in reverse (counterclockwise).
3. Place burnishing end of tool into damaged screw; slowly clean inside screw head until smooth.
Removing:
1. Insert burnishing end of GRABIT® directly into drill; removing end is now showing.
2. Maintain reverse setting (counterclockwise).
3. Place remover end of tool into smooth screw head.
4. Apply firm downward pressure; drill at very low speed.
5. Remover end of GRABIT® will thread into the head and remove the screw.
NOTE: Burnishing tool end is not to be used to drill holes.
CAUTION: Any cutting tool may break or shatter under improper use. Government regulations require use of safety glasses and other appropriate safety equipment at all times in the vicinity of use.