Lenox® Carbide-Tipped Hole Saw

• Effectively cuts materials that standard bi-metal hole saws will not cut
• Carbide teeth provide better chip formation and faster cutting rates than carbide grit edge or high-speed steel
• Greater wear resistance and higher heat resistance than bi-metal hole saws – last up to ten times longer
• Designed to handle tough, abrasive materials
• Three teeth per inch
• Tooth hardness RA 90 – 93
• Teeth are welded to backing material
• 6° to 7° positive rake
• Precision-ground angles and clearances
• Triple chip ground tooth form
• 1-1/2" (38mm) cutting depth
• Elimination of set collapse
• Smoother, concentric cuts
Cutting Recommendations
• Plumbing: Ceramic tile, fiberglass, cast iron
• Metalworking: Stainless steel sheet, aluminum
• Composites: Computer flooring, Formica, plywood, plastic, particleboard and Corian®
NOTE: Carbide-Tipped Hole Saws use standard arbors. We recommend the use of Carbide-Tipped Pilot Drills when using a Carbide-Tipped Hole Saw in hard abrasive materials.
CAUTION: Any cutting tool may break or shatter under improper use. Government regulations require use of safety glasses and other appropriate safety equipment at all times in the vicinity of use.